@powerlines2000 Good to know! Thanks!
Tkgato
@Tkgato
Best posts made by Tkgato
Latest posts made by Tkgato
-
RE: 5-Pro Silent / TMC Con Err / Solved
@sameerjc Hi, unfortunately since I wrote the post I have changed the firmware due to the installation of the BLtouch tool.
Did you check here for a newer firmware?
https://www.creality.com/download
Regards
-
RE: V4.2.2 bltouch firmware for Ender 5 pro, no Z offset, incorrect home
Hello
I had the same issue with Auto Home results: X=70, Y=107, Z=10
What I did is go to Motion > move Z axis value resulting from Autohome to 0.00 (do not try to adjust paper thickness here, this is only to tell the machine were the cero is)
Then go to Bed Leveling > Prove Z Offset and adjust the thickness there (paper thin)
Then Save Settings
To test run Autohome again and yes you will get a large number on Z but if you go onto motion and move the Z axis to 0.00, it should result in the paper thickness you calibrated.
I hope it helps!
-
RE: Ender 5 Pro V4.2.2 / BLTouch / Display not working
@Tkgato I just solved the issue by...well I have no clue, I guess you have to really push "gentle" which is not a good thing for monkey hands me. So, if you get the display not working, check and re check the connections on the pinnboard and good luck!
-
Ender 5 Pro V4.2.2 / BLTouch / Display not working
Hello
I just installed the BLtouch kit from Creality and my display is not working.
There is only one way to connect to the Pinboard A the ribbon cable so I am clueless as to what is going on. Upon removal of the pinnboard the display works correctly.
I am running the latest firmware: V4.2.2-Ender-5 Pro-32bit Mainboard-Marlin2.0.1-V1.3.1-BLTouch.bin
Thanks for your help in advance!
-
RE: TMC connection error
@KaosKurt Hello, I just flashed my machine: Ender 5Pro with silent board with this file and it did removed the message. I hope it helps
-
5-Pro Silent / TMC Con Err / Solved
Hello
I just finish the build and got the error upon boot up.
I've flashed the machine with the file named "Ender-5 Pro- Marlin2.0.1 - V1.0.1 - Endstop.bin" and it did remove the TMC Connection Error message from the UI in the Ender Pro 5 with silent board.
I hope it helps.
Regards