@telephasic Well, at least it is working now and I am having some fun printing things. Thanks for your help and input. Cheers// Mike (tucats)

@telephasic I know this sounds very strange but I started to use a new micro SD card. Now when I slice and save everything is working as it should. hmmmmm...

Well, I am ready to give up. I still have the same problem (the object begins printing at the home position) and no matter how many changes that I make to X and Y my prints fail at this location. I have to figure out how to get the print to start in the middle of the plate.

@SteveDee Thanks! That helps me a lot. I believe I now know why my projects won't print properly. I will make adjustments before I slice. I am printing the cat again from the SD card and it is coming out perfect in the center of the bed. Cheers.

Where is the 5 pro home position? And what does that actually mean? I have only printed a couple items. I'm a newbie and the software learning curve is steep. I printed the cat from the SD card and it came out perfect. Then I tried a few items from Thingiverse, the LCD cover came out pretty good, everything else has failed. It seems like the nozzle always parks itself in the back right corner and every print wants to begin from there. It should begin closer to the center of the bed. Is that correct?

Thanks for the help. I think that I have it now. Printing my first (the cat) as a test. Here's hopeing all goes well. // Tucats

I don't see any nuts under the hot bed. Unless you mean to tighten the 4 knurled knobs on each corner of the bed. I guess that would squish the springs down tight. But will that lower the bed?

Hi folks, a 3D newbie here.
I have built my new Ender 5 pro and am trying to level the bed. It seems as if the bed is sitting too high in the auto home position because I can't get the sheet of paper under any of the 4 corners. Even with the 4 knurled knobs slacked right off the board is too close to the nozzle. I can get the paper under if I press down on the bed but then I can't move it around at all. How do I get the bed to go lower so that I have a bit of adjustment with the knobs/springs? Thanks for any comments you may have. Cheers.