I've switch to TH3D firmware for my ender 5 pro, WOW!!! i must say, everything is solved, now i have control over the printer, and can save the settings to the EEPROM.
UNKNOW
@UNKNOW
Best posts made by UNKNOW
-
RE: V4.2.2 bltouch firmware for Ender 5 pro, no Z offset, incorrect home
Latest posts made by UNKNOW
-
RE: V4.2.2 bltouch firmware for Ender 5 pro, no Z offset, incorrect home
I've switch to TH3D firmware for my ender 5 pro, WOW!!! i must say, everything is solved, now i have control over the printer, and can save the settings to the EEPROM.
-
RE: ender 5 pro messed up coordinates
restore setting by uploading a new firmware to the printer, or the same firmware, it will erase all setting (i think)
to keep the printer less depends on SD-card is buy a raspberry pi and install octopi to it (google/youtube octoprint for more information)Off topic.
(im still waiting for the admin to answer about the EEPROM, why we can't save settings to it) -
RE: Ender 5 Pro 4.2.2 Marlin echo:No EEPROM.
@admin so, you agree the setting is NOT store on the EEPROM, but the Sd-card?
isnit wierd? i mean, if you have a faulty SD-card, then you can't run the printer without doing the calibration again and need to do this each time you have turn off the printer.i know the EEPROM memory is writeble, since TH3D firmware allow you to do this, so i dont know why creality holding this option back for consumer.
-
RE: Installed the v4.2.2 bltouch firmware for my ender 5 pro, but can't seem to adjust the Z offset.
@hfzyem Control --> bed leveling --> probe z offset....
and ofcuz, you need to have the right firmware installed to see it. -
RE: Ender 5 Pro 4.2.2 Marlin echo:No EEPROM.
i have the newest version installed with bltouch, AND no, the setting is not saving to the eeprom, its save to the sd-card,
i did as you said, bed leveling, then go into the z offset and dial in the number, then save it, so far so good, but if the sd-card is not insert and the printer have restarted, all setting is back to factory settings.
ask some of your tech guy to test it byself. -
RE: Ender 5 pro V4.2.2 BlTouch installation question
@admin the youtube video is not a ender 5 pro, how to follow it?
-
RE: Cable extension
i also want to know if there is a code for, each time the 3d printing is done, the level bed will go down eg. 200mm for better handling for removal of the 3d print....
-
RE: Ender 5 Pro layer weirdness
@admin how can we set the retraction speed to 80mm/s in cura 4.7? Everything over 50 turn into orange color.
-
Cable extension
Hi, just bought a ender 5 pro a week ago, everything is functional except the heat board are impossible to get it flat, made a order on bltouch unit, hopeful it come soon.
However, I wonder if it possible to extend all the cable for the printer without losing functionality, I like to have a clean setup, but with all this exactly length of cable it's hard to do this.
Can someone name all the connectors that I need so I can order it online.