@MaxS I have the same question.
Z
znolo
@znolo
1
Reputation
2
Posts
1
Profile views
0
Followers
0
Following
Best posts made by znolo
-
RE: how am I supposed to use the flexible bed?
Latest posts made by znolo
-
RE: Filament sensor stopping the print
@rjamison I checked my filament sensor, and it is true that when you take the top off the enclosure the board moves around a bit, as it is sitting freely on two posts projecting out of the bottom half of the enclosure. However, there are two bosses projecting out of the upper half of the enclosure that press down on the board keep it from moving very much when the enclosure is screwed together. On my unit it certainly does not move around enough to cause a false filament reading.
-
RE: how am I supposed to use the flexible bed?
@MaxS I have the same question.