I know there is an issue with the camera on port 8000 with this firmware and I can confirm. Is anyone else seeing the cfs losing the reported filament levels and seeing them revert back to 100% sometimes? Or is it just me? You can refresh them and it updates but goes back to 100% after a power cycle or 2. The types doesn’t change, just the amount of filament.
I have not seen the filament levels revert back to 100%. Mine on my K2 Combo seem to be holding steady.
The camera is indeed an issue and I reported it to the Creality Support team. Their devs are investigating.
I am also seeing that CFS filament levels never changed for me from 100%. RFID spools are detected with correct names and colors but no change in filament usage displayed.