I have had my k1 max for about two years now, i got it as a Christmas gift. I’ve been having issues with bad prints for a few weeks now though and i’m not sure how to fix it. I replaced the hot end with the creality upgrade twice and they both failed. So I just got the micro swiss upgrade. Things seem to be over extruding, but I can’t get anything to stick or stay to even try to do flow rate calibration. I also have the textured bed from Creality. I’m just not sure where to start to try and fix it. Any help would be appreciated.
Did you do a PID tuning of the Micro swiss hot end when you installed it? You may have temperature fluctuations which could contribute to pore print quality.
Bill
1 Like