Calibration Tutorial/Guide in Creality 6 is Enlightening, but Needs a Refresher!

Software Creality Print V5 and Beyond
, ,
1

Greetings fellow Tinkerers!

I’m loving my K2 Plus, I literally shed some happy tears upon it’s first calibration after unboxing! Ha, yep, sure did! Input shaping sounded EPIC as it was powering up!

Trying to master Creality Print 6, and capitalize on the features it offers. Right now I’m utilizing the calibration models made available.

When clicking the tutorial, it has a few of those features noted. But, it is missing a large majority of them! Does anyone know if, or when they may be updating that guide?

I’m looking for the acceleration/deceleration tutorial info. There are others I find would be super helpful, not only for me, but a lot of users out there.

Thanks for stopping by! :smiley:

2

That is just so … na, can’t think of the right word … sounds like :upside_down_face:

Don’t forget to check in on it at it’s bed time :grin:

1 Like
3

HA! :laughing: Oh yes! Over here watching it print from the Creality app camera when I can’t sleep :sleeping: :eyes: :sleeping: