Can I pause, turn the printer off and resume the printing later?

Ender Series Creality Ender-3 V2
1

That said, I don’t want to leave it printing all the night without my supervision, so can I pause, turn it off and resume tomorrow?

Thanks

2

The print will probably lose adhesion to the bed when it cools so I wouldn’t recommend it. Leave it printing should be fine.

3

So were it not for the adhesion issue after coolingh down, the printer is capable of resuming?

4

Yes it is but if the part isn’t stuck to the bed you’ll make lovely spaghetti mess. A good fresh glue layer might be able to save the part.

5

afcourse its not your question, but i also put a clock between it.
this i set the time in my phoneapp, when to shutdown, when it is finished

finished at 6 oclock i shut it down at 7 oclock.

afcourse it is still running at night what you dont want, but at least it shuts down when finished.