I am on my 3rd extruder motor after installing the. cfs-c on my K1C. I followed the install video/ directions, routed the wires properly, and installed the firmware off the USB drive. Does anyone have any tips or upgrades so that I dont have to replace the motor every month
CFS-C is a new product. It’s not well-tested. There are many problems with it, especially with the firmware. The best option is not to buy it, and I hope Creality won’t take offense at this opinion! Their technical support has been unable to resolve my issues with CFS-C and K1c for over a month!!!
WBR, Alex Kojanov