Creality CR-10 Smart Pro hot end leaking

CR Series Creality CR-10 Series
1

Hey all - my son has recently become interested in 3D Printing - have not used my printer for a bit its a CR-10 Smart Pro. Went to run an articulating lizard out for him and about 10% in I see a chunk of plastic draped all over. The silver block that the nozzle protrudes from is coated in drippy plastic. Can anyone help a total newb in how to disassemble and either repair or replace this part? I see videos and such of the silver metal cube/nozzle part with no wires and some sort of threaded shaft already in hand… but how do I get to that point and where do I get new parts for this?

Thanks!

1 Like
2

I have a disassembled CR10 smart Pro here with all kind of parts.

Also a MicroSwiss All Metal Hotend Kit for Creality CR-10s PRO.

With hardened and brass 0,4 mm nozzles.

You can buy it cheap for say 40,00 euro (including thermistor and heater) and some other hotend parts if necessary.

If you are interested send me a message to work it out further.