My printer dont find the centre - A 215mm circular print, and i dont get a round print. Please - any advise?
Hello !
Just to confirm, the firmware is “Ender-3_HW4.2.7_SW2.0.9.03_SpriteExt_H300” ?
Yes. I did send an email with photos of the print. Thanks for helping
Ok - being a while. I figured out that my x limit switch was 1cm to far to the back….. but this did not solve all. So i also notice that when i push and pull the haed forward and side ways that it could not move all the way to the right - the bottom bolt that made the direct drive mount was sticking out to much and catching the horizontal framework. So i did some modification and fixed that problem. Then i printed a 220mm square to see — i got a print size of 208 x 208 for a 220 x220 print??? i checked my orca slicer (ender 3 pro .8mm head) settings and it show the bed size as 220x220 - why is it still not printing 220 x220? this is realy getting me work up. Please help with any possible solutions! PLEASE!