Creality Print V 6.0.2.1574 - Filament Start G-Code not inserted into G-Code file!

I am using (on Orca) for some filaments which require a higher z-offset the filament-Start & End-G-Codes to define this speciality.

Example of change I do:

In Orca slicer I had never a problem with that but in CP6 I find in G-Code only the FIlament End G-Code, but never the Start-G-Code!

p.s.: The feedback link which is in CP6’s help menu linkls to an outdated page and CP http://as.cxswyjy.com/slice/#/OnlineSupport?serverEnv=1&language=en&software=CrealityPrint&version=1.9.350&deviceId=A0A399E66AB1830CD6AF875258ED15CF

I hope that Creality people watch this forum as well because their other ways of providing customer support are really bad!

2 Likes

i’m experiencing the same bug.
The start-gcode is only included like comments on gcode.

Same Problem here for Spoolman
SET_ACTIVE_SPOOL ID=4
CLEAR_ACTIVE_SPOOL
both dont work

Did you try latest version 6.0.5.x? It should work now.