Hi, I have just purchased a Falcon A1.
I have been using an Atomstack 5 with Lightburn for a number of years.
I need to cut 1/16" bulsa wood with tabs so the pieces stays in the sheet. I can do this in Lightburn but can find the opetion in design software. I have looked at the help but can find it.
Is it an omission in the software?
Stuart.
I guess the answer is it can’t be done. I’ll have to go back to LightBurn then.
Stuart
The lightBurn online documentation has a section on Tabs and Bridges. Tabs are pulsed cut.
Here’s the link. This is a legacy link, I have the latest (I think) LB and it has tabs too.
Hi CoGregg a typo in my original post “I can do this in Lightburn but can’t find this function in Design Software. I have looked at the help but can find it”
Stuart.