I recently upgraded my K! SE to CFS with kit and had multiple errors after the install.
- CM2852 Filament detector triggered abnormally, possibly due to an external material rack being used with CFS
- TC2841 Cutter issue, cutter might be jammed, pleas try again after resolving
- CY5286 Y-axis print coordinates out of range
The first item was due to the cables on the new extruder were not fully seated. I have big fingers.
The next 2 were cause by the positioning of the nozzle during setup. I didn’t realize that the dirty nozzle was catching on the nozzle wiper. After cleaning the nozzle and rerunning the alignment, it works as expected.
For give any nomenclature mishaps, I am fairly new at 3d printing.
Tim