Dead Ender 3 s1 pro with an "ab.temp" error

Came home the other day to a blob of PLA encasing the entire extruder housing and the AB.Temp error message.


Opened a support case and didn’t really hear anything back. Then opened up a chat with support and they said they didn’t think the product would be under support so I asked them what I should do. They told me to pick up a new sprite extruder and that should address the issue. I picked one up and it was delivered today. I hooked everything back up and set the manual temp so i could add filament and the same AB.Temp error came back up.

Anyone have any suggestions other than the extruder assembly that could be causing issues? As I’m down another $100 and not sure where else to look.

1 Like

I have the same problem. Replaced the Ribbon cable, Heater Cartridge tube, Thermistor and Nozzle but none of these fixes solved the problem.