Hi guys! I have a few 3d printers and I recently bought an original Ender 3 off of Facebook Marketplace and put in a new motherboard (the 4.2.7). I updated the firmware on it (Ender3Marlin2.0.6HW4.2.7BLTouch.bin Firmware from “Ender-3 Marlin2.0.6 CR-touch or BLtouch firmware) and when I got to the bed levelling with the BLtouch I had, it went to the corner and tried to autolevel in the air, off the build plate. This obviously shouldn’t happen and I am confused why it didn’t work the way I thought it would. Do I need to go into the .bin file and change the offsets for the probe? What would be the best way to do that? I haven’t had to do make any changes in the .bin file before before so I would like to make sure I do it correctly before I make any changes. Any help would be appreciated. Thank you!