Hello all!
I am very new to 3d printing, only about 2 weeks in. I bought myself a cr touch, but I am very lost.
I have tried all types of different firmware, from the “cr or bt touch firmware” to Marlin-2.0.1-HW-4.2.2-mainboard-V1.1.2-Compatible with ALT and filament detection"
The first firmware, the motors refuse to move. It gives the error “auto home failed please reset” which I do just to run into the same error.
The second firmware, it seems to work okay, but is very temperamental with the files I put on the SD card. When I put the sd card in, it says on the screen “SD card inserted” but when I go to the menu it says there is no tf card. But I turn it on and off again and it’s there. But that doesn’t work all the time.
I have an ender 3 with a 4.2.2 motherboard
Any advice is greatly appreciated!