Hello folks,
I have just upgraded Nozzle and fan by the kit ~ https://www.aliexpress.com/i/1005005581382468.html and printed the holder https://www.printables.com/model/148897-ender-3-s1-twin-jet-5015-fan-duct. Unfortunately I am facing the issue that Ender is not able to recognize bottom “Z” level. It goes down and push the surface however probe lights (purple). I tried reset configuration in menu but no luck.
Video: Watch unnamed | Streamable
Did you observe similar issue, please?
Any suggestions?
Thank you so much for any advice!
Best regards
David