We’ve had our v2 upgraded with a Ender 3 Sprite Direct Drive Extruder Kit for about 9 months and working great and just recently ran into a weird issue. So far its one specific gcode thats about 18hr print. The first attempt we sliced with Creality Print and it worked fine but then i resliced it a few times w/ Prusa (which is my main slicer ) and each time at some point during the print (its different each time) the print will continue but the extruder gears will stop working so it stops actually printing. If i stop the print and try a new print or filament change the gears still wont work until i turn the printer off/on and then i’m good (except when i kick off that one print). I’m still troubleshooting but curious if any one had any idea if it could be hardware failure or maybe something that Prusa is doing w/ slicing that file specifically thats locking up the extruder