Ender-3 V3 SE setup

Hello forum.

I was wondering if anyone can help me out with a set up issue. I just unboxed and assembled my printer. When I powered it up, the dispaly console asked for the language choice and once selected it skipped directly to calibration.

The problem I ran into was with the printer module. It seems to be stuck and attempted to move. There was a lot of jerking motion and to avoid damage I turned it off.

Has anyone experienced this?

Thanks,

Manny

Hello LogHome2017

The first thing I would suggest is check the the voltage is set to the country you are in.
Then try again.

Cheers.

I switched it to 115v and there was no change.