I am new to 3 d printing and I am leveling the print bed. I am on the auxillary leveling and hit position 2 and it nearly took the printer head off the plate. It looks as though I did something very wrong but don’t know where to start. When I hit the home button it puts it in the center of the build plate so I am not sure how that position is so out of whack?
Hi @Jpeck and welcome to the forums.
I would recommend winding the bed screws so that the springs are approx half compressed, this should give you enough adjustment room in both directions and allow you to get the corners set correctly.
Be sure to go around the bed 2 or 3 times during the AUX leveling to be sure all corners are correct and you should be fine 