I’m always getting a 2253 error message on my cr-10 SE when I try to print out something, I have already turn it on and off and unplugged it plus also doing a firmware update but the error message is still the same, what should I do?
I don’t see that number in the Wiki or in the source code.
So contact Support.
https://wiki.creality.com/en/cr-series/cr-10-se
I have stared getting that error on my Ender 3 V3 Plus. After a loty of swearing, i then paid close attention while the file tried to load and saw that the nozzle temperature was trying to set to 1500C!. My original settings were 220C (for PLA) so I don’t know where it was coming from. Having got it to load correctly, everything worked.
Having read other posts about this error (which Creality still appears to be ignoring) I am coming to the opinion that it is a prompt for you to carefully check all settings!