cant make sense of this.
when i cut larger items (bigger than say 7")
all cut pieces drop out clean,
but on smaller pieces it leaves 1 tab on each cutout hole,
very frustrating for small delicate items.
any clue why this is happening?
i believe i may have solved my problem,
so in case others ever have this problem ill give my findings.
after adjusting every belt and screw without results i was defeated,
i started wiggling everything today,
and noticed the left side y axis had some movement,
tracked it to the wheel underneath the rail,
adjusted the nut and no more wiggle
could kick myself for not discovering this sooner lol