Firmware for Ender 3 with 4.2.7 board, cr touch and direct drive

Ender Series Creality Ender-3 S
1

I’m looking for firmware for an ender 3 with 4.7.2 board, Cr touch and direct drive. I’m currently running Marlin Bugfix 2.0.

2

I doubt you will find any farmwear for your combination. Do you know how to compile marlin using VScode?

3

Ender Series Firmware Download | Creality 3D Printer Firmwares

4.7.2 ? You mean 4.2.7 ? :sweat_smile:
Ender-3_HW-V4.2.7_SW-V2.0.6_BLTouch would be great then

Concerning the direct drive thingy, I don’t think it is changing much in the firmware ?
From my understanding, it will only need to change the retraction value in the slicer, no ?

4

Depending on the direct drive you will need to change the extruder steps ie for the creality sprite extruder will need to change 98 steps to approx 480 steps. This may not be available on the standard creality display therefore the requirement to compile you own firmware.