Focus CR-Laser Falcon 10w

Scanner & Falcon Creality Falcon
1

Hi Creality comunity.

I have some issues with my Falcon 10W
I already have a S9, and thought i would like to engrave a bit faster, more power etc.
And was satiesfied about my creality 3d printer, so i looked for a creality.
so i bought a cr-laser falcon 10w. (second hand) with low burning time.

I was looking forward to compare the 2 engravers since im a bit on the limit of my S9.
Now i engraved exactly the same part, used same program. only reduced the power from 95% to 50% since the creality has twice the power.

But to be honest i was a bit suprised there is so much diference in these 2 lasers.
it almost looks like the falcon if not on correct height, but i checked that twice,

Can some one tell me what iam doing wrong or is this just the quality i can expect from a older Falcon?

Here you can see the comparrison of the 2 parts i made.

20240926_185342
20240926_1853421920×2560 384 KB

20240926_185350
20240926_1853501920×2560 353 KB

Thanks,
Danny

2

Can you check for loose belts and other loose parts first?
You are using the highest of the three steps of the leveling piece?

3

Thanks for your reply,
Yes,I already re adjusted the belts, and rolers.
Everything is good before i started.

And also yes i use the highest step.