Hey folks,
Curious if anyone else has noticed strange feed issues with giantarm pla (in my case matte gray pla). Also right out of a tight vaccuum pack seems might have not be so dry as during extrusion consistent steam was coming through. When trying to move it through the tube via spooler there seemed to be a bit of resistance at random points.
Sorry, never heard of them.
I tend to stick with eSun and Sunlu as I have found them to be quite reliable/consistent.
Cheers.
It may have been packed whilst not entirely dry. Put it in a filament drier for at least 6 hours and your consistent steam should be cured. Random resistance could just be down to wet filament.
Ah, thanks a lot. I tend to let things that fail me not get returned on time, so instead of waiting for me to be stuck with a couple of potentially bad spools, I returned them promptly.