so, i was printing something for an animatronic project and then suddenly, it stopped printing, made a loud beeping sound and when i checked, heatbed was too cold. i turned it off, back on. it worked again. then it was halfway done, error happened again. and that wasted alot of my pla+
i checked if the connectors were disconnected or broken, it wasn’t so now i am completely clueless on what i should do because, technically, my printer rn, is a huge block of scrap that won’t print.
do i have to get a new heatbed, should i get a new printer under the low low price of 400 bucks, do i have ti replace the motherboard??? i litterally need some help right now