Ender3 v3 ke
everything stock
standard print settings
auto calibration and auto z
I’ve replaced all the parts in the bed (Creality Sent):
Base
Hotplate
Magnetic Sticker
All connections are secure and everything is calibrated. Parts are tight. Now I can’t get even close to a decent first layer. I think I’ve had a defective CR Touch from the start. Is there any test? This is the best I can get without the nozzle gouging the plate.
In order to best help, it’s important to give as much information as possible in your questions. At the very least you should include the printer you are using, any modifications you have made (hotend, motherboard, firmware), and what you have tried so far. Things that may seem inconsequential could be the thing that triggers another person to remember a nightmare of a fix that took them forever to figure out. It also can save a lot of back and forth and people suggesting the same solution again and again.
