Ok there is something really wrong with the software.
I did the following points:
This draws the outside border of the square/polygon:
0x0 is front left of the bed if you are looking at it from top down. So drawing a square from bottom left (0x0), to bottom right (300,0), to upper right (300,300) to upper left (0,300) back to bottom left (0x0)
0x0, 300x0, 300x300, 0x300, 0x0,
Then same thing but inner square now which is 10mm in diameter:
10x10, 290x10, 290x290, 10x290, 10x10
Which when defined w/in Creality Print v7.0 in the “Excluded Bed Area” I can see the excluded gray area, BUT the stupid program thinks my object is touching that area and I can’t slice/print. 
Did anyone at Creality test this?