I have a question about software working with hardware
How do creality print pressure advance and motion advance on the K1 max are working together (the K1 max screen says the motion advance is only working with the creality print slicer
) or don’t they work together at all.
So what is the choice to make :
creality print 5.0 PA enabled and motion advance (K1 max) at “on”
or creality print 5.0 PA disabled and motion advance(K1 max) at “on”
I got my answer from creality:
the first answer was :
On Thu, 13 Jun 2024 at 08:50, 创想三维（官方客服） <cs@creality.com> wrote:
Dear Customer
You can find this section in the filament settings.
my response was :
I knew that I could find it there but that was not my question.
the question was / is :
So what is the choice to make :???
the second answer i got was :
Op vr 14 jun 2024 08:25 schreef 创想三维（官方客服） <cs@creality.com>:
Dear users, we apologize for the inconvenience, please be patient and wait for the official release of version 5.0
my response was:
I have crealiity 5.0.
Please Answer my question
the third answer i got was :
|### 创想三维（官方客服）|10:29 (1 hour ago)||
|
| — | — | — |
|to me
|
##- 请在此行以上输入您的回复 -##
Hello! Your request has been updated. To add additional comments, please reply to this email.
Dear users, print PA needs to be disabled, and fans need to be disabled
