I see and I perform/Thank you

Flagship K Series Creality Flagship K1 & K1C
1

I saw there was some chat at some expo about CFS for the K1C. Nice! I cannot wait…

and to anyone having trouble with “heater not heating as expected” or prints stopping in the middle of the printing. Check the fans in the middle of the print. Sometimes, the cooling overpowers the heating. Creality has done a good service with this machine so far and I would like to say thank you. So, thank you…

Outside of that idea, I see there are ways to change just about every preset available. This is awesome in itself. I like options. Also, if by chance I have missed it in the v6.0 of Creality Print in the slicer or some preset, where are the settings to handle the air flow during printing.

It is like I had it up and I was changing settings and then I could not find the setting any longer…

Seth

P.S. Maybe my current setting does not allow for it since I have a saved setting parameter?

2

Also…I just found the Carbon setting for the printing. Yes! I was printing CF-PLA without the Carbon option. No wonder I was having so much trouble…

3

I found it…

No issue now…the preset for fans is an expanded option under Filament on the top-right hand side of the GUI. Then once I click the down arrow (black arrow on my GUI) and click the Pen Icon, a Filament settings pop up is displayed on the GUI.

I can use the Cooling option to adjust fan speed at different intervals.

Seth

P.S. If this helps, enjoy. If it does not assist well, okay.