Issues after installing BLTouch and Sprite Extruder Pro ender 3 pro 4.2.2

Ender Series Creality Ender-3 Max & Pro & Neo
, ,
1

I have ender 3 pro. 4.2.2 MB. I recently upgraded to the Sprite extruder pro and BL touch. I followed instructions for installing both. I updated the firware to the new hardware. When i go and try to level the bed, the printer moves to the “Home” location and then back to the center and does nothing. It doesnt even change the Z position to go lower.

The BL touch does light up red but does nothing. Ive tried searching for more info. BUt coming up short

2

My Ender 5 plus did something similar once, I manually wound the Z upto the the BL touch. Once it was in range and the BL touch touched the bed all was good. Had a sticking BL touch probe once also, manually retracting it worked too.

3

I cant manualy wind the Z. Everytime i “home” to level the bed, it goes to center and is raised about 2 inches up. Havent tried printing yet