I am having a dimensional issue with my x axis. The y axis pretty much spot on, 0.9992. z axis is 0.99. The issue I have is X AXIS 0.9788. In Creality Print 5 the shrinkage compensator assumes filament shrinkage and adjusts both x and y travel. Does anyone have a solution or something I maybe missing? I don’t want to go down the rooting path but I will if that’s the only available solution. Another problem I have with CP 5 is my computer freezes up when printing longer prints and even crashes at times. I found that part of the problem are new radon graphics updates on an old windows 10 system.
My BAD. The problem was dirty bearings in the carriage. Printing a lot of ABS and even though I clean the rods, the bearing pick up and hold deposits.