Printer just have one day working. Printed HyperPLA without problem. Now started printing with ASA (260-100-55) and camera loses conection few minutes prior to print start. Once the print ended, I reseted the printer and the camera worked fine… till I started printing ASA again.
Could it be a temperature issue??
i have the same problem.
I’m sure it’s a temperature issue. I just made a print in PLA (220-50-34) and the camera worked fine the entire time. With ASA (260-100-50) it stops after half an hour. Shortly before stopping, the image begins to pixelate. The camera housing burns because it gets so hot.
Yes, it has something to do with temperature. When the temperature reaches 60 ℃, the camera will be turned off to protect it from being burned.This was done after a firmware upgrade.