Hi, everyone. Sorry my first post is a problem and not helping someone.
I have 4 Creality printers and i haven’t had many problems that i did not cause myself (often being too impatient).
I have an issue with my K1 Max and wondered if anyone else has come across it.
When my filament runs out part way through a print, the head moves to the side and i can then refill after changing for a new spool.
When i then restart the print, it is not going to the same place as before the pause, it is offsetting the layer to the left by approximately 2mm.
This then totally ruins the print and i have to throw it away.
Has anyone encountered this, and if so, have they found a fix?
Thanks
Neil