K1C Layer Number double in Creality Print Device page

Software Creality Print V5 and Beyond
1

When printing the current layer displayed on the Creality Print Device page is double the number it actually is, it adds two after each level is completed. I had not noticed this until after installing the latest Creality Print update ver: 6.1.1.2274 I also recently installed the CFS accessory upgrade.

2

Does this problem still exist in the latest version（CP 6.1.1.2274)?

3

Yes it does.

4

This issue is for sure a firmware issue. Started after installing 2.3.5.33 for supporting the CFS.

Yesterday I got to know that Creality released a new version (2.3.5.34). I installed it today on my K1C to test but this issue is still present.

1 Like
5

I agree, mine is still incrementing the count by two on each level. Seems to be pretty isolated to a small amount of machines, wonder why ours have that problem but very few additional upgraded K1C’s have this issue ?

6

Is this issue still being resolved? I’m using a K1 with a CFS upgrade, and the layer count doubles even in the Creality mobile app. As a result, I can’t monitor the camera in the Creality Print software. The camera screen turns off before printing is complete.

7

This week I found that the Firmware that was shipped with the CFS Upgrade was probably not the right one for my K1C, which has main board version CR4CU220812S12.

I was checking the official firmware page ( Flagship Series Firmware Download | Creality 3D Printer Firmwares ) and I notice a newer firmware for my main board model: CR4CU220812S12_ota_X2000E_V1.1.0.27.20251225.img

However I am currently running the latest firmware that was provided by Creality: v2.3.5.34 and the file name is: CR4CU220812S11_ota_img_V2.3.5.34.img

Which means that this firmware is for a older main board version. Not sure if that could be the root cause of some of the issues.

Anyway, I copied the latest firmware for my mainboard to a pen drive to try updating it. And guess what?
My K1C is not detecting new firmwares via pendrive…

Now I am not sure if this is an issue with my printer or with the current firmware or because there is some sort of version checking that prevents it to be installed since the most recent one for my main board has a smaller version then the firmware I currently have.

Does anyone knows? And how can I force the installation of the new firmware using pen drive?