Hi, what do you think this bed leveling problem could be? When I canceled the job, the nozzle scratched the bed so badly that it was already level. It’s a new K2plus, not even a week old.
@AtreyuARG is this still a problem? The post says May-17, but it just showed up in my new posts. If you are still having issues. You said this is a new printer. check that the leveling screws are tight, then run the auto calibration again. Take a look at the bed mesh in Klipper, tuning section. You can reach Klipper in a web browser at http:///4408/#/tune