The print head moves to the center of the plate and touches down, before going back and doing the purge strip. I want to prevent this, as I want to create an inlay into a previous print. This technique works with Cura on my Ender 3 V2. (Leave the previous 2 layer print in place, keep heat on, replace filament with new inlay colour, then start new print with Z-hop to avoid touching previous print.)
The pre-processing G-code for the KE shows only the G28 (go to Home position), nothing about moving over to the build plate center.
I am using Creality Print, LAN Printing from my PC.