Hello all. I just unboxed and setup my Ender 3 V3 plus. I powered it on and waited for the language setup screen. It did popup, with English outlined. Almost immediately an error screen popped up with Key:2000,Unknown exception. There is an OK button in the lower right. On pressing it a 2nd screen with two(2) button pops up. The left button says “Restart”… The right button says “Fault reporting”. On pressing the left button, there is a wait, 15 - 30 seconds, and it returns to the language and error screen. On pressing the right button a message pops up stating " You need to bind the Creality Cloud first". It then also returns to the language and error screen. Has anyone seen this before and/or has a fix. This is a brand new unit. It has zero(0) printing hours. I am hoping that this is not an Out of Box Failure(OBF).