I have been down for health reasons and now getting back to using the machine.
The last prodject I did, before getting laid up, was using the rotary. I disconected the rotary and reset everything to just do some wood engraving.
After making sure everything was updated, I created a job through lightburn. Then when ready, I hit frame, and the laser module through a fit and stayed in the corner. I have looked into a few different things and still cannot seem to get it to respond properly.
It does move freely and if I move it to center by hand I can get it to do some type of frame yet not even close ro what I am doing.
Can anyone please help me figure this out?