I have an Ender 3v3 Plus, where I sometimes do multi-color printing, where Creality Print is configured to pause the print on filament changes.
The draw-back - I need to follow the progress of the print using the slicer - otherwise it can be a bit hard to know which color to insert, when the printer is paused.
Is there no way of adding some gode, that could put up a message on the display telling that the next color to be used is number #x (in the slicer, they are numbered from 1 and upward). That will make things a bit easier - until I at some point probably invests in a Creality Hi Combo, so I don’t have to struggle with manual filament change any longer…