I have a modified Ender 3, that I have been printing with for sometime. I have an auto-off in “G-code”, after printing to turn the Ender 3 off after it cools down.
Lately when I “turn-on the printer” (by moving the heat bed back a little) the nozzle and heat bed temp’s start to go up. I usually print with ABS and have problems getting the model off the PEI flex plate, The bed temp in Prusa slicr is set to 98c but if you look on the display, it’s up to 120c, the max I set when compiling Marlin “G” code thru the “Marlin Firmware Builder” great for software nob’s like me.
Any thoughts would be greatly appreciated
the nozzle is zero but it’s reading 27c and the bed is set to 99 but reading 118, I just set it to this temp to scrap the ABS off the build plate. I do have an adhesion problem, the stuff won’t come OFF without heave scraping
Somewhat Stock Ender 3, Microswiss DD, Skr mini E3 V3 control board