I’m fairly new to Creality Print, running V5 on my Mac, and I think I might be missing something obvious when it comes to the profile settings for different materials. I’m using a K1-SE.
I’ve run a few PLA prints using the Hyper PLA “Filament” setting, and then in the “Process” section I adjust my speeds, infill, etc.
I now want to test a print with CR-PETG, so I select the “Filament”, which works fine. But under the Process section, nothing changes. Like the speeds are all still PLA speeds. I was expecting a default configuration I could select for PETG settings. I understand many of the settings would be the same, more or less, but the speeds should be drastically different.
Am I expected to search out what these settings should be? Or is there a default configuration available for the different materials as well?
