Hello everyone,
Does anyone know where o get a 310x315mm heat bed? I can only find 310x310 but yet the magnetic build plate i have is 310x315. When I was looking for the build plate, I was told to get the 310x315 which didn’t make any sense when the specs say it’s a 310x310. So, do I get the 310x310? I’m soooo confused.
Hello @shootingblanks00
Welcome to the Creality Forum…!
On the Creality site it shows the Ender S1 plus with a 300 x 300 build plate.
What printer do you have…?
I saw this:
I’ve never ordered anything from them so I can’t give a review…
Cool! Thank you. I’ll buy it using Paypal so I will at least have some form of recourse if something goes wrong.
I thought I’d have to replace my heated bed last month, turned out the hole in the case where the cable fed through was too narrow and had eaten through the protective sleeve and the power wire. (Non-stop high-speed printing for ~6 months tends to cause a lot of friction on tight parts.) I repaired the wire first using solder and heat shrink wraps, then when I knew it was working I replaced the whole wire just to be safe.
About an hour of effort and 10 cents of materials.
Not saying it’s for everyone, but in my case I couldn’t even find a suitable replacement part in my country and the Creality US site only appears to offer shipping options within the US, so I had nothing to lose repairing it myself.