I’d like to request a feature that allows users to manually control or influence the start and end anchor positions of bridges in Creality Print. Currently, the slicer automatically chooses bridge anchor points based on geometry, but in many cases the anchors end up too close to the edge of a part even if the wall number is increased. This leads to weaker bridging, reduced dimensional accuracy, and increased sagging. A deeper anchor could in many cases produce a stronger, cleaner bridge. A “Bridge Anchor Offset” parameter (distance inward from the edge) would be great, there is clearly already some parameter driving this, I just need access to it. The pictures show a generic example of how adding more walls doesn’t fix this issue.
