Simplify compared to Orca

Ender-3 V3 Printers Creality Ender-3 V3 Plus
1

Now that I have gotten the printer profile from Simplify for the Ender 3 V3 Plus, I am comparing the difference between the 2 slicers with the same model and filament.

Each have areas where one is better than the other, both using the stock settings.
The overhangs are much better on the model where I used Simplify (Model on the right).

I’m wondering which settings control this feature in Orca as I’d like to figure out why the Orca sliced model looks so bad.

PXL_20241204_135426034
PXL_20241204_1354260341920×1440 286 KB

2

Both the retraction and Pressure Advance settings have an impact. If the retraction is too slow, there will be excessive filament leakage, and an uncalibrated Pressure Advance may cause corner protrusion or insufficient extrusion.