Afternoon Everyone,
Some background. Had issues with Bed leveling. Loaded community firmware, didn’t work. Then decided to go klipper, for bed level mesh, to see if my bed is warped, and for print speed improvements. (Apparently klipper is the easiest and cheapest way to get speed improvements) but after a week having issues with bed mesh and leveling, not 1 single print would make it past layer 2 or 3.
So I decided to load the community firmware again…. Not sure what I did differently this time, but ran bed level, and Z-Offset was automatically set. So I left it as is and started a large flat print… well we are coming to the end of that 20hr print…. And the 1st layer was near perfect… and so is the rest of the print…
Done with my ranting… back to the reason for the post… Im looking to get some speed gains to reduce print speed… Im NOT looking to make it a 600mm/s printer. Im aiming for 200mm/s. So what upgrades would you guys suggest?
And has anyone attempted a “speed upgrade” on their CR-6 MAX?
TIA
