"The nozzle temperature is below the minimum extrusion temperature"

[Radical_Data]

Hello Juneau,
Is there a shop in your area that sells 3D gear such as filament ? if they do, they may sell cleaning filament.
I have used it before and found it helpful in some cases.
Otherwise there is a post by tjan that may be helpful.

K1 max filament jam

You need to clean the heater throat (first take extruder apart and of and take the nozzle of) that allows the filament through by heating up a round iron wire and push that through so attached restfilament is pushed out. be careful when doing that. after that the filament will glide through much easier. You have to use a bigger round iron wire that fits the heaterthroat diameter I had that same problem last month and it worked for me. there is a video somewhere to be found as guide

Cheers.