TPU printing Help how to configure settings in Creality Print V7 for Ender-3 V3 SE

Software Creality Print V5 and Beyond
, ,
1

Hey there everyone I’m very new to 3D Printing in general and more than a bit Autistic so as much detail you can give in your answers would be appreciated greatly but I have a Creality Ender - 3 V3 SE printer and while I have been using Creality Print for slicing and making my Gcode and using I have had great success with PLA and I got some TPU and my first few attempts have me very discouraged the flow that’s coming out of the print nozzle is incredibly inconsistent with it making these 1-2mm globs then 1-2mm thin strands creating walls that are more like infill the current setting preprogrammed in Creality Print V7 don’t seem to work and the info I can find about printing with TPU is either very vague or meant for another brand of printer or software specifically so any help in setting up the printing settings inside Creality Print V7 to print with TPU on an Ender 3 V3 SE would be greatly appreciated

The TPU filament is 95A and has a label stating print temps 190c to 210c for 50-80/mm/s and 210c to 230c for 80-120mm/s

2

Hi Joey,

We use 95A TPU on a Ender s1plus, its fairly similar to the SE, we use bed temp 70 and nozzle of 228. Check your Z clearance so that it gives an even and squished line of filament on the surface, it should not be round topped as it is too far away from the bed.

When you have got this about right, do not calibrate before every print! Saves time and reduces the alterations you need to make to get a decent print.

K