Trying to Figure Out Why the Print Keeps Stopping

Flagship K Series Creality Flagship K1 & K1C
, ,
1

Hello There,

Seth here. My print keeps stopping after the fan for the hotend cools the hotend to the point that it stops heating consistanting (I think).

Is there a way to handle this issue without software?

I have tried slowing down the speed of the print and other supplied feature changes. All of which are failing with the builds I create on Alibre Atom3D. I am not plugging Alibre but I use them for saving .stl formatted files to print with your GUI and slicer source.

Now, the selling point of this printer was 600mm/sec. There is no way to print past 100mm/sec. on most prints from what I have seen.

Seth

P.S. Please send guidance.

2

I slowed down the unit fan and the hotend fan also…

This is proving valuable on printing plus I used the source GUI to set up the printhead at a higher temperature with a hotter bedplate.

Seth

P.S. We shall see…

3

All is well again…

Seth